what is the difference between LT and HT power supply?
Answer Posted / sajjad ali
1 to 10
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
In TNC switch, is there any 1NO+1NC block ? and if we move over closing position, is ther any affect on trip position or vice versa?
how to calculate cable size in diffrent loads?
Explain marx circuit.
What are the advantages and disadvantages of the ac motors?
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
What is ignition module of a CAT Gas Genset G-3508 Engine, Alternator SR4B Series. HOw its checked for correct functioning.Is it repiarable or replacable?
Damping resistor provided in open delta (tartiary) winding of a measuring PT at the incoming of a MV inverter drive panel is getting heated up. Can any body explain the reasons and suggest the remedy?
What is the normal phase difference between the voltage and the no-load current in a transformer?
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
how we start 40w tube light with 4 diodes,2capacitors,1 choke and without starter.(a product avilable in market which lights burnt tube lights also)
What is the formula for selecting the cabels according to load? How to calculate what sq.mm cabel to be used?
Difference between HRG and NGR. Are they both the same thing
i m doing DEEE in part time,can i join regular cources in BE,,IF i join what the cources can i select like (civil,ece,IT) ,,kindly advice
how to select the mpcbs and contactor for 3 phase 30 hp star delta motors.for plc control.and tell me the calaculation for future use.
A 11KV, 1200 A breaker combination fixed in a cubicle for HT motor.Is normally for 11 KV motor fuse is using? if Yes, What range fuse is required?