what is the difference between synchronization and paralleling?
- 13 Answers
- 39266 Views
- BARC, I also Faced
- E-Mail Answers
Answer Posted / bhagavatsinh
synchronization is the process where voltage , frequecy, and phase angle must be same. but in parelleling it differ in acceptable tolerance. I.e. you can parrellel a two transformer which have a voltage 11kv and 11.5 kv and freguency 49.80 Hz and freguency 50.20Hz and phase angle according to vector group
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
A mass of 1200g is accelerated at 200 cm/s2by a force. The value of the force required is:(a) 2.4N(b) 2400N(c) 240 kN(d) 0.24N
can anyone please help me to find the rupturing or breaking capacity in KA of circuit breaker (MCCB,VCB,ACB etc) of HT and LT side of a distribution transformer...please help with detailed step by step answer...thank you
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
What is sensitivity of a measurement?
if a.c supply is given to the motor,, what happen?
HOW DOES THE ELECTRONIC ENERGY METER WORKS?
1) Explain why we don't link the two earthing system ht and mv on a pole mounted transformer sub-station.
what is the ms flat constant for calculating earth mat design calculation?
WHAT IS THE MEANING OG (li = 7 In)
Can anyone please provide me details of MCCB/Contactor/SFU rating calculations for a motor feeder..for example 50 kw.. not from type-2 cordination chart. i want manual calculations..
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
Which is the oldest hydropower plant in india?
what are pilot cells
mention hazard experienced during installation
What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works?
