Interested to Buy Any Domain ? << Click Here >> for more details...
how 1.52 factor comes while calculating no of bags of
cement...from 1:2:4 design mix?
- 4 Answers
- 19318 Views
- CCCL, L&T, Vishwa Infrastructures, I also Faced
- E-Mail Answers
Answer Posted / er.balasundari
This 52 means dry volume to be considered always 50-55%. We can choose those 52 r 53 r 54. Bt mstly choose 52%.Hence it is 1m3 + 52%= 1+0.52 = 1.52. This s very crct answer.
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
what is project?
What the advantages and disadvantage of using 90mm and 100mm bricks for a wall of a house? Thanks for any input.
How to Know that veriation acceptable in CPWD Work Of 1:6 Cement Mortor Received Lab test report.
Why you are leaving present job?
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
Why are the bolts that hold steel rails together in oval holes?
IS code for grade of concrete for bamboo lintel????
if we use 1.25 bag of cement 3 pharma metal and 2 pharma crush sand what is the strenghtexpected for RCC column
Mention what are the composition of a landfill?
can we find any technical issue if we are gong to change the dimensions of steel beams from one type to another type IE if there are any equievelant data base to find solution for problem of changeing sectios of beam from one type to another with the same cross sectional area.
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
how to prepare site mix design
What is Curtailing of R/F
Wats the formula of eccentric footing and how was calculated from concrete qty
