how to change the load sharing between two synchronized
identical alternators when both are running with Diesel
engine? assume both are feeding to same feeder?
Answer Posted / k.prakashchandra
Fuel input decides the load . If gen has to share more load ,try to increase the speed.
Is This Answer Correct ? | 0 Yes | 5 No |
Post New Answer View All Answers
In single phase ac ups supply when current is measured with tong tester neutral current is found more than phase current.What is the reason?
An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm
how to check ac servo motor
HOW THE OLTC TRANSFORMER SAVE ENERGY IN COMPARISON TO OFF LINE TRANSFORMER AND IS IT ECONOMICAL TO REPLACE THE OFF LINE TRANSFORMER TO OLTC TRANSFORMER
What is the function of a neutral reactor.
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
what is mean by descripiency relay? & wht is its ansi code?
why h parameter are called as hybrid parameter?
Why the efficiency of generator is more than motor in swinburne's test
What is the difference between earth fault protection of motor feeder with CBCT and Without CBCT ?
Which power will flow first if we switch on a motor Active or Reactive? How?
Earth is a conductor or load?then ammeter connect to 3- phase supply,it shows the measurents or not?
hi all i like to know vat is power plot in control systems also i want to know abt latest trends in electrical & electronics
What is the Difference between Ac Drives and Dc Drives? According to application, speed, Torque, cost, Reliability, Construction, Motor etc... Thankyou !!!
What is deference between MCB & MCCB & ISOLATOR