Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / alok
Master plc receive the information and send command signal to slave device
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
a flow transmitter [range-0-400mbar] connected in process line. please explain me how to calibrate the flow transmitter , & how to do static error
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
in differential pressure transmitter,min&max pressure range for hp&lp
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
please tell no. & add. of consultancy who recruit me in power plant as instrumen engg. present i m working in power plant as ass.t instrument engg. thanku mahesh 09226562826
what is the importance of CV in the control valves? how it is calculated?
model question paper of instrumentation for Jindal GET 2010.plz reply sudhanshukumar08@yahoo.com
Why thermo wells are used? What materials are used in thermo wells?
Positioner usage.
What is the start up procedure of desalter
How to calibrate level transmitter with use of HART?
In Safe Guarding test what means by "Failed to Danger" ?
what is the responsibility of an instrument commissioning supervisor
