Interested to Buy Any Domain ? << Click Here >> for more details...
What is meant by 'zero value' in quantity surveying.
- 10 Answers
- 43213 Views
- DLS, Gammon, HCC, NCC, I also Faced
- E-Mail Answers
Answer Posted / sameer kashmiri
The difference of initial estimated cost and final estimated cost or Actual cost should be zero or near to zero.... its called ZERO VALUE
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the diff between cad & cadd?
I Want To Know Quantity of Cement Conc. & Sand in Column of 9"x9"x10'
How are freeway bridges built?
How many are the types of joints?
what is the theoritical percentage of concrete cubes testing per day?
How did street originate in the plumbing term street ell?
What is the Systematic Responsibility Site Engineer? Who are the above and under co-oridinating ? What is office & Site co-ordination of Site Engineer?
plumbing CPVC fitting FTE Brass full form
Dear Sir What is the Contraction joint for base Slab
With reference to construction of state highways, please let me know the total Bill Of Quantities as per the following details:- 1) Subgrade - 500 mm 2) Granular Sub-Base (GSB) - 200 mm 3) Wet Mix Macadam I (WMM I) - 150 mm 4) Wet Mix Macadam II (WMM II) - 100 mm 5) Dense Bituminous Macadam (DBM) - 60 mm 6) Bituminous Crust (BC) - 40 mm Road Length is 44 Kms. Road Width is 7 mtrs. Please provide the BOQ of each layer as per Compacted Factor & Loose Factor both. Also, if possible please provide me the approximate details of total material required (all categories viz. soil, gravel, stone aggregrate, sand, bitumen etc.) as per general mix design prevailing in India. Thanks & Regards -- Rokr
HOw much % of premium on DSR-2013 currently
How much form and scaffolding per cubic meter volume of concrete class ''A'', ''B'', and ''C''
What in your opinion makes you the most suitably qualified candidate for this post of civil engineering technician?
As we know that steel is a tension member but why we are using STRUCTURE STEEL as a COLUMN (Without concrete) where column is a compression member and compression strength of steel is very low
what is the proper procedure in conducting a california bearing ratio penetration test on soil on cbr machine?
