Why earthing transformer used in Distribution Sub-Station?
- 3 Answers
- 11081 Views
- I also Faced
- E-Mail Answers
Answer Posted / deep
in delta connected t/f winding has not neutral point to connect to ground and beacuse LG,LLG fault is sensed by zero sequence current so providing earting on delta side we use earthing t/f.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why is using sensor?what is differece between photoelectric and proxmitty?
How generator NPS(NEGATIVE PHASE SEQUENCE TEST)TEST WAS DONE? PROCEDURE WITH DETAILS?
Dyn1 transformer vector group testing how to do
l&t switch FN 63 handle position can we change
From past few months I am getting lagging pf even though sufficient capacitors used in circuit. Where is the problem pls answer
How shall i select the value of capacitor or inductor in a system?
In the formula : Knee point voltage = Burden X alf / class, Please inform what is alf? regards Shashidhar M.R.
what happen if generator of micro hydro running at only a small percentage of its capacity, as a comparison, if the diesel generator that runs on only a fraction of its capacity there will be a wet stacking
How does the slip regulator works as a startor
Tell me the reason of connecting domestic t/f primary in star or delta,and also secondary side.
in dc series motor if field wdg is shorted then
how to calculate the earth fault current
Scott connection is used for A 3-phase to 2-phase conversion B to achieve higher effciency C to save copper D to reduce harmonics
What is mason's gain formula?
how to calculate the conductor size for certain KV transmission line and distribution line?
