.What are the equipments should run when there is a black
out in power plant.
- 5 Answers
- 7921 Views
- I also Faced
- E-Mail Answers
Answer Posted / anbu
DG set and DC Emergency oil pump should run to lubricate turbine and generator bearings. If DC Emergency oil pump got problem means lubrication oil will supply by overhead oil tank.
| Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
why is the in steam turbine axial displacement of active side thrust pad is positive and non active side thrust pad is negative.
Looking for Bently Nevada surplus 3300/52-01-00-00 Reverse Rotation Monitor , 4 pieces.
what's the moog valve
procedure of how to generate power in solar plant.
why airtel use + 24 volts and other operators use -48 volt
We have Demin Closed cooling water system with expansion tank for cooling oil system. Expansion tank having N2 bladder. Whenever N2 bladder bursts out, Closed cooling water circuit pressure drops and make-up happening, eventhough there is no leaks. And how Circuit pressure drops?
explain how the third harmonic content of the magnetising current affects transformer design
How to calculate boiler capacity? I have 1 Autoclave, Which has to use for AAC block. Dimension for this Autoclave is - 13 Meter Length & 2.2 Meter Diameter.
By any way can we increase the B check hours from 300 to 500
What is LB-SR.
how to differentiate between "ALL fuel lost" and "All Fuel Lost" in Boiler MFT condition?
How do you consider that you can improve and what assistance do you need to achieve this
DCS marshaling Cabinet Power supply can be replace during plant running time? Answer Yes it is possible. I am talking about the controller and cards power supply modules. They are always redundant and connected through diode so that if one power supply fails the other can take the charge immediately.so it is possible to replace one of them in running plant if the other one is healthy. MY question is how switching done.
can dp type level transmitter work in under vaccum condition
What is surging in a centrifugal compressor ? How it occur's ? How is antisurging done ?
