WHAT IS DIFFERENCE BETWEEN TWO WIRE RTD AND THREE WIRE RTD?
Answer Posted / yugesh shah
Commonly 2 wire rtd used wher the place rtd installed and control room where indicated the temperature is not so far
But where indicator and rtd is in distance the third wire which is known a s compensation wire is used to stop of the effect of temperature which is in atmosphere and in process area...so if u wanna exactly temperature then should use 3 wire rtd
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
How can measure flow in oil line?which type of transmitter is generally used?
why we are using drum level control valve air to close?
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
what is diffrance between FF & SMART, explain with difination
What is the difference between modbus,fieldbus & profibus
we have level transmitter for h2s04 storage tank capacity 10k ,always there are failure of transmitter due to failure of magnetic floats ,please come up with solutions at the earliest.
how will you segregate the alarm levels in alarm management system during factory Acceptance Test
Questions on flow meters,few questions on HART protocol,
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
Name different parts of a pressure gauge. Explain the use of hair spring in the pressure gauge.
Sir,I am going to sit for IOCL written test exam. recently.Can anyone tell me the name of 'Objective type Question Book on Instrumentation Engineering ' which will help me. Pl. mail to bidyut_71@rediffmail.com / bidyut.saha2008@indiatimes.com / bidyut.saha09@yahoo.in
In turbine what does term CDP, NH, HSSOC means.
What is exact difference between the panel earthing and system earthing in DCS system. What is the value of resistence.