Interested to Buy Any Domain ? << Click Here >> for more details...
Why Parallel operation of two Transformer are Required?
- 6 Answers
- 14635 Views
- I also Faced
- E-Mail Answers
Answer Posted / prasad
I would like add a point to reena:
Generally we choose transformers with same capacity and impedance for redudandancy in Process plants to avoid power interruption to process.. and we do paralleling of trfs to carryout load shiftings without interruption especially critical loads.. (this is not in the case of lighting etc. where interruption really doesn't matter.)
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
1.4 What is meant by CT knee point voltage and how would you determine it
WHTA IS LIMT OF LEAKGE CURRENT OF 11 KV 1 CORE 1000SQ.MM. XLPE CABLE.LOAD ON CABLE IS AROUND 600AMP .LENGTH 500 MTRS.
How phase displacement change in the over current relay coils.
What is the difference between diode and a transistor in terms of the direction of current flow?
What is 11 N1 and 12 N2 in single phase Transformer ?
How can we find out LT UG cable fault (size,from-4*25mm sqr to 4*300mm sqr)? How mani types UG cable faults?
what is Fault level? why it is calculated? how will u decide same for our plant?
derive DC RMS value for half wave rectifier?
application s to shunt coil
You are of electrical field and you are going for software? Why
How can we measure the residual voltage in dc machines?
how to build a network which step down 415v to 1v rms
Why we used 690V in ACS 800 drives.Why dont use standard voltage like 415v or 1.1Kv
What is quadrantal symmetry?
Electromagnetic torque developed by the motor is compared to shaft torque. A less B same C depends on motor design D more
