Interested to Buy Any Domain ? << Click Here >> for more details...
what is the meaning write of AC1,AC2,AC3 .....power contactor
- 7 Answers
- 35592 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / abdul rehman khalid
This applies to all AC devices (loads) with a power factor of at least 0.95 (cos phi greater than or equal to 0.95).
Example of use: resistive load, heating, distribution.
This applies to squirrel cage motors where breaking occurs while the motor is running.
Example of use: all squirrel cage motors, lifts, escalators, conveyors, bucket elevators, compressors, pumps, mixers, air conditioning units, etc.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
i am going to correct power factor of 1600kw induction motor,when i calculate capacitance of capacitor it is three time more in star connection than delta. if motor is star connected which connection i shall adopt for capacitors and reason for adopt this connection
What is deference between MCB & MCCB & ISOLATOR
what are factors comes under relay setting (distance relay 7sa52) under OPEN DELTA VTs connection??
what will be the effect if you were using different brands of outlets?
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
is it possible to turn on the single phase star delta on delay timer using 24 v dc ?
Why magnetic flux produces an induced current?? what is the detailed procedure ?? ans plz
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
What is the Nyquist criterion regarding control systems?
How does a digital electronic meter work??????
how many joint can done in HT line and what is life of the joint
I WANT BHEL PREVIOUS QUESTION
What is the size of a 60 watt and 80 watt tubelight?
we have consol make 3 phase servo stabilizer for cnc m/c. while installing the earth neutral voltage is 1.7 volts at stbilizer off condition and when stabilizer get on en voltage reaches 4.8 volts (new earthing is done and neutral is helthy condition all phase to neutral volts 440,442,441 v)why this happen.solution for cause.
what happens when series resonance occurs?
