Interested to Buy Any Domain ? << Click Here >> for more details...
Why winding temperature ct placed in B-Phase of the transformers??
- 3 Answers
- 4174 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
My answer was for ' A B C ' sequence . If it is ' R Y B' ,then the reason may due to presence of the tap changer close to R & Y phases
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
how to calculate the settings for shaft ct protn in hydro generators
Why current shoots up in the secondary on the knee point voltage during saturation test of CT? How core saturation effects the secondary current (while the primary side is open)? What the logic behind this?
difference between a diode and thyristor?
armature is that part in which current is induced since in dc motor we supply current to the conductor so why we call it armature?
what are the industrail measures to over ferranti effect? how would the ferranti effect the power system if those remedial mearsure arent taken? how often does this effect occurs in real power system?
what is star delta starter? how it works? give its control and power diagram.
I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
What is the function of NER and NET?
why ht cable end termination don't have a gland?
i am trying to PSUs/govermeant jobs since last 2 years but still i m not success, plz help me.
How to design pavement quality concrete by using C.R.C.P Method
What are the no-load losses for the 11000/415V transformer with the following rated capacity? 1.1500 kVA 2. 2000 kVA 3. 2500 kVA 4. 3000 kVA
The 3 phase 400 hp 440 volt slip ring induction motor do not take one phase amps why ? The motor is running good condition
Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example?
