What is the Requirements of indoor & outdoor Substation
Construction?
What is the main Safty Requirements for SubStation
Construction?
Answer Posted / firoz khan
Erosion and sediment control.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How much river sand contain the 6 & 10 wheeler truck? Or Maximum sand that any type of truck carry?
how much used soil in 1 brick of standard size?
what is diversion?
What do you meant by gui?
How do we determine the specific gravity of a cement?
A 16 pile group, consisting of diameter concrete piles, were cast in situ in a clayey soil whose unconfined compressive strength is 1100 psf. Each pile is 60 ft long and the pile spacing is 2.5 times the pile diameter.The water table is at the ground surface and saturated unit weight of the clay is 118 lb/cu.ft. using a factor of safety 3 and a reduction factor =0.45, compute the allowable capacity of the piles acting as individuals
in 2 way slab can additional compressive reinforcement can be provided if yes than in which conditions it is required ?
to minimize budget cost of building , what can i do
Why Should Curing Not Be Done By Ponding And Polythene Sheets?
100mm block work 64 bags of cement used 150mm block work 286 bags of cement used 200mm block work 20 bags of cement used patly work (M15) 293 bags of cement used mortar ratio is 1:5 how to calculate volume of sand in cum & no. of bags
how to caliculate required amount of cement and sand required for 1cu.m.
How to design staircase.plz tell me formula for the design the staircase.
) Design a gussetted base for a column section consisting of one sc 250 with two cover plates 300 x 25 mm carrying an axial load of 2500 KN. The S.B.C. of soil is 250 KN/m2 and the permissible bearing pressure on concrete is 4000 KN.
How to make a c++ program that converts any base to base 10?
why steel tanks are provided (a) for water pressure (b) for wind pressure (c) for earthquake pressure