Interested to Buy Any Domain ? << Click Here >> for more details...
extremely urgent please, why a fuse is used before
voltmeter but not with a ammeter connected to a CT(current
transformer),thanks in anticipation.
- 4 Answers
- 10067 Views
- NPCIL, I also Faced
- E-Mail Answers
Answer Posted / manan2347
Because during fault condition high transient voltage will occur thia voltage can damage voltmeter that is why we connect fuse across it, while in case of CT metering CT are made up of special core that can get saturated if voltage across its primary is beyond its limit, so no more current will flow during this condition, so there is no need to connect fuse with CT.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
why u r living from presentaly working.
Dear Mr B C pal...Can you plz. put some light on principle of operation of Z-Ct in conjunction to its use with 1Cx1000Sqmm HT Cables & Directional Ground Fault / Over Voltage Relays...Regd..Parag v K 9899115632
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
In the N-series schneider reclosers. What is the difference between current during fault time and current at tripping? This appears in the Event log in an event of a trip out.
how does it help for selection of a transformer.
How to checked frequency drive output voltages?
How earthing of switchgear system to be done.
What is the maximum operating temperature for a thermoplastic insulated cable?
Operation of isolators.
What is EHT tariff or Power factor Tariff ????
i have some screw comprressor with 630kw power,i have established them with simple star to delta circuit,by the way there is so much inertia when the screw comprressors start, can you offer me contactors power with 400vac or any cataluge to choose the contactors
what is the mechanical safety of DG ?
explain the functions of main isolation switches
can any one tell me about the Extra low voltage systems?From where we give supply to these type of systems??
In our factory so many iron pillors are exists for supporting the shed/Hangar. If do more no of earthings at one piller instead of doing more earth pits in many locations and running earth strip around the hanger, I can save the money. Please suggest this method is acceptable as per Is specifications though the Earth resitance of the farthest piller is with in the limits as per IS specifications.
