Interested to Buy Any Domain ? << Click Here >> for more details...
what is the formula to calculate isolated footing
- 11 Answers
- 101242 Views
- Supertech, I also Faced
- E-Mail Answers
Answer Posted / pawan kumar
V=LxBxd+((h/6x(A1+A2+4Am))
where
d= base height
h=total height - base height
A1= bottom area
A2=top area
Am= mean of area at mid section
| Is This Answer Correct ? | 8 Yes | 5 No |
Post New Answer View All Answers
How much cement and water required for cement selery????
The properties of concrete HA-30 and how does it differ with M 30 (specify the important characteristics like workability,strength,mix design,slump test value)and what is the standard relating to it
How can you distinguish between sorption, absorption and adsorption?
How we calculate the service time of buildings
Dear Sir, I work in hydro project. I want to hire Scorpio/ Bolero on monthly basis. But how can i justified its amount (Hourly basic). Please solve my problem
What does a construction cost covers and what does not?
I want to know the relevant IS codes of practice which deals with different testings of cement-sand mortar (nominal mix)that is being normally used for brick work or plaster work in the construction work.
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
What are the points to be considered for calculating cement reconciliation. a)Do we need to deduct the wt of cement bags b)Do we need to adjust the qty due to wt loss during transportation, loading unloading etc or else each bag can be considered as 50 kg bag c)What is the proportion of mix cover block making.
How do you calculate reinforcement weight of steel?
What is meaning of tlc
the magnitude of the buoyant force can be determine by newtons law of viscosity archimidies principal principles of momemnt none
Which ratio use for cement selery???
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.
How many pyramid in egypt?
