Which is remain unchanged in transformer action?
Answer Posted / pritish
flux can also be the answer
Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
how could we calculate the no of outgoings from a 800 watt distribution board
what & how to check the lightning arrester
Difference between RCCB, RCBO and ELMCB.
How to decide whether A / B / C / D curve type MCB should be used?
list the type of vfd? wich is sutable for heating kiln?
sir i applied for hpcl(electrical).i want to know from which subjects most of the technical que will b asked.and pattern of the written test.pls help me
what are the parameters plays a major role in Potential transformer Burden calculation??
how can tell us the AC indoor or outdoor which Tr and formulls
what is current check gurd relay?
Hello Guys !! i want to rrb section engineer electrical(signal) previous model papers? any body help me?
What is step signal?
witch pump used in wtp
We have drive feeding an output contactor for a 5000 hp motor @ 5kV application. The motor FLA is 629amps x 1.25% service factor = 786.25 amps The cable that we current have in place between the drive and the output contactor is 350kcmil- MV-105 (parallel cables). Per the NEC table 310.60 (C) (69). This show the cable ampacity is at 615 amps per cable for a rating of 1230 amps. We have derated the cable for the cable tray and the multiple cables application and our calculations show that after the correction factor factor we are at 922amps. 1230 amps x .75% correction factor factor = 922.5 amps. The customer is driving us to then use another safety factor of .25% off of the already derated cable. Can you please provide a longhand calculation for your solution on this application?
What is meant by reset level of the relay?