Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / divusp
on design part in the structure.must be completed M.tech in structural engg.
1. ensuring sufficient of structural member sizes that architecture given.
2. arriving steel requirement for structural members.
3. ensuring safety of the structure.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
i have to give lap joint fo 1Mtr steel of dia12mm,whenever i did mistake i cut less 5cm plz tell me how much i will give lap joint so that length comes 1Mtr
How much of fly ash is allowable in Portland cement and what is the disadvantage when the level of fly ash is increased?
For fine aggregate which is most suitable River sand or crusher sand & why ?
Dear sir, i want to NBCC & NTPC previous exam papers email Id : madhu_bingi@yahoo.co.in
what is mean by reestimation?
What are the different methods for drawing an arc?
how to calculate the scour depth
What expenses counted in contingencies and how much it is in related to built-up area of the building.
what should be the PCC ratio to construct a plinth of (40x40x4)ft...??also its estimated cost??
Process of pcc in wateredug
density of crush sand & crush stone or grit powder
how to calculate valuation for the old building?
How to hide dimensions in autocad?
Different sizes of Hollow blocks and its weight. Thanks.
For the symmetrical continuous beam shown in figure, Prestressed with a force P = 1500 KN along parabolic curve as shown, compute the extreme fiber stresses over the central support for the uniformly distributed load of 24 kn/m. Use load balancing method.
