Interested to Buy Any Domain ? << Click Here >> for more details...
Why we not use the impedance relay in protection of short transmission line ?
- 4 Answers
- 8762 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The impedance too small to be measured
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What technology is used in latest generators?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
I don't understand why when we connect high voltage source in DC to electronic motor , we must add capacitor and resistor in parallel ? (I know that we use capacitor because we want to absorb the current that in the first second electronic motor in opposed with current course produce. ) what are the feature of Resistor and in such situation ?
How much ph is maintained of water electrolyte which is used in LRS for 1200 kw slipring induction motor ?
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
In siemens PLC, why do we want to move the data ?
Why lose 1 phase voltage in 33kv to 415v stepdown transformer
A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.
how can we understand that where we have to use ac or dc coil for solenoid valve and why?what is the different between coil of ac and dc explain please.
What is the role of power pack in substation protection system?
How to calibrate or test an LT Air Circuit breaker 440 volts, 35 KA, 800 Amps ?
WHAT IS LOAD CELL
If we need 4c× 50mm sq cable but it's not available so we can pull 4c×25mm sq two cables?
HOW CAN WE DECIDE THE SUPPLY VOLTAGE FOR MOTOR ACCORDING TO ITS RATING(IF ANYONE KNOWS GIVE IT WITH EXAMPLE AND ITS CALCULATIONS)
How to do bus bar short circuit calculation for 230KV/11kv, 60 MVA Substation?
