Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ganesh
AMF panel is the short form of Auto Man Failure panel. It is normally connected to the generator set to control the generator set function. It can call the generator set if the AMF further connected to the Main Switch Board ( received power from the other source - normally from the local authority ) which equipped with auto transfer switch/automatic changeover contactor. While normal supply serve to main switch board failed, the AMF board will send the power failure signal to generator set. Then the generator set will run and serve the supply to main switch board.
| Is This Answer Correct ? | 10 Yes | 4 No |
Post New Answer View All Answers
what is the use of permanent magnet generator in exciter
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
how hazordious area is classified at an oil & gas plant and categorise suitable class of electric equipment in that area like induction motors, LCS, Lighting Fixtures Fluerescent/Flood lights Mercury& sodium lights, J.Bs, Power Cables etc
I'm looking for a mnaual set for a Teradyne J750. Softcopy would be preferred but I'll take what I can get.
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
Why slip ring ind. motor power consumption is low compare to induction motor .same 90 kw motor used same load output
What are the advantages of speed control using thyristor?
i want to know d working mechanism of tafe tractors next i like to know d engine type of apache bighs can anyone help me
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
how to estimate wiring ins roughing ins. and boxes
what is the advantages og idmt relay over magnetic relay??
How to design harmonic filter at the project stage without nowing the harmonics levels
How to choose the vector group for the step up and step down transformers??? Tell me the which vector group is suitable for step up and step down transformers and whats the reason to choose and whats the benefits???
where solid grounding and where grounding through ngr done and why?
how to setting voltage RTCC panel
