Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate the phase diffrence beetween given two equetion y= 15sin(wt+pi/3) and y=10sin(wt-pi/4)
- 1 Answers
- 3283 Views
- I also Faced
- E-Mail Answers
Answer Posted / brandon
First of all, the phase has no association with the amplitude of the signal, just in case. Now, to calculate de difference, you simply sustract both phases, in this case:
phase 1 = +pi/3
phase 2 = -pi/4
So, the phase difference would be:
pi/3 - (-pi/4) = (4pi+3pi)/12 = 7pi/12
which is 105° in the degrees scale.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
How to calculate the Harmonics losses in terms of cost/unit.
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
can i use 2000/5A Clamp meter to measure HT cable
What happens if we run alternator on under frequency?
WHAT IS MEANT BY OVER EXCITATION IN GENERATOR TRANSFORMERS? DESCRIBE IT.
what's the difference between abs/inc encoders. apart from the position remembrance what are all the other differences. and what's mean by grey code.
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
how much leakage current is allowed in MC61A L&T make relay?
why magnetising curve not start with zero voltage?
HOW TO TEST A LIGHTENING ARREST ER ?
What is gain margin?
Define non-touching loop.
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
Define super node?
block diagram of 2 ups system connected in parallel mode?
