Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / aa.
Lap Length is provided at the end of rod to maintain its continuity.
Normally, it is 50 times dia of bar/rod. But it varies depending on types of stress it undergoes i.e. direct tension, bending tension and compression.
It also depends on dia of bar/rod, Grade of Steel & Grade of Concrete used. Because, higher the bond strength, lower is the lap length. Bond strength is higher for higher grade of concrete.
Similarly, higher is the strength of steel, higher will be lap length.
When two bars of unequal sizes are used, lap length is calculated based on lower dia.
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
WHAT DLC DESIGN IN CONSTRUCTION
In earth work 1300 cum soil how to calculate how many liters require in water
Can you pl explain the procedure steps of singly and doubly reinforced beams in limit state method
Under what circumstances should pot bearings be used instead of elastomeric bearings?
Before casting a basement roof slab which is connected with retaining wall surcharge load (i.e. sand or earth filling) outside the retaining wall is prohibited because of––
why & what is perchatage we are using fly ash in concrete?
Will going from a 3-tap to 6-tap increase water pressure?
How should we design a brick column and footing?(note: no reiforcement to be provided) Can you tell me any reference book where i could possibly find this design? Plz help urgently
Doul Bar reinforcement and details of drawing.
What are the advantages of cad software?
Why we provide hair pin for shed
dialation means
what is the list of building construction equipment & teir output?
cement required for construction of 400mm*200mm*200mm concrete solid blocks for 1sq.mtrs,how?
Gave a cantilever beam with 3 legs.Told to draw the bending moment diagrams, axial force diagrams and shear force diagrams.From BMD he asked to show how the reinforcement will be provided on the tension side.
