Interested to Buy Any Domain ? << Click Here >> for more details...
in our sub station why we step down firstly 33kv\11kv then
11kv to 430v. can we direct step down 33v to 430.v.
- 7 Answers
- 14688 Views
- I also Faced
- E-Mail Answers
Answer Posted / gsamguna
we can use 33kv/ 440 transformer
who said cannot
if u want 33kvto 440 u want to install two transformer
33kv/11 and 11/440v
this s stupit answer ..
sure we can use 33kv/ .44 kv directly step down
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
Diagram and details of polarity test for Current Transformer 11kv 400/200/100/1A
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
what is the reactance,capacitance & impedence electrical armoured & unarmored Cables.
how we calculate torque ? how we improve it ?where torque will either motor or generator ?
If a air condition consume 2.50 to 3.00 amp then how much it will consume in watts if it is running 10 hours out of 24 hours????
Logic using 1 kV or 1,1 kV grade in house wiring Low voltage cable. Explain/suggest? some use 1kV and some prefer 1.1kV grade insulation low voltage cable why??
how we control automatic generator i'e with to supply (main supply and local generator) when the main supply was break to supply the local supply automatically to begin supplying power.I now this control circuit is the combination of contactor time delay contactor switch and overload relay .but my question is how we combine those component thank you
What are the uses of lead compensator?
We have 110Vac ,10A ac supply which is converted into 110VDC & How much DC current? which factor is reqired for dc current calulation?
What would cause a 240v choke that should give 110v out on a 16w lamp to gradually increase to 160v?
what is meant by 3rd hormonics ?
Good morning: I'm looking for some informations about the OLTC or the LTC: I wont to know what the function of the tie-resistor in during the operation of reversing/coarse operation Cordially
What is meant by harmonic distortion?
Brief me about maintenance planning & sheduling of machine tool.
What is current & voltage ? Voltage perform at any load without current or not?
