Interested to Buy Any Domain ? << Click Here >> for more details...
What are objectives of energy managements ?
- 1 Answers
- 4085 Views
- Kirloskar, RR, I also Faced
- E-Mail Answers
Answer Posted / vinay krishna
Objectives are resource conservation, climate protection and cost savings, while the users have permanent access to the energy they need
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
R=*¶ l/a
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
1. A 380 / 220 V r.m.s. 3-phase 4-wire circuit carries loads of 8 + j8.1 ohm; 4 + j4.1 ohm; and 2 +j2.1 ohmin the three phases respectively. The length of the circuit is 100 m, and the resistivity of the phase conductors is 0.0005 Ω/m. The neutral conductor is of the same size as the phase conductors. a) Select a reference angle 0for the first phase. Then write down the three phase voltages in both polar format and complex number format. b) Make appropriate assumptions, and take temperature effects on resistance is insignificant. Calculate the currents in the three phases. (Note: Determine conductor resistance, and apply Kirchhoff’s Voltage Law) Based on the result, suggest a main switch rating for the circuit. c) Show your preferred direction of neutral current in a diagram, and then determine its value. (Note: Apply superposition principle, and Kirchhoff’s Current Law) Use its magnitude to show that in this circuit, the unbalanced load may increase the voltage drop in some of the phases. (Note: Also observe the common volt drip in neutral) State your assumptions, if there are any. d) Suddenly the neutral wire of the circuit is broken. Estimate the new currents in the first phase, i.e. Phase L1. State your assumptions, if there are any.
the grid connection required for a 50 MegaWatt fotovoltaic powerplant is higher or lower than 35kv (high or medium tension)?
How you will determine the volume of oil in a particular Distribution transformer.
Explain the functioning of diode?
please send 5yearje solved papers on my email himmatsinghnathawat@gmail.com
Circuit diagram of tube light without starter using electrical choke
If a high resistance fault occurs,then what are the changes will happen in the system?
What will happened if the neutral of the (star connected secondry) Xformer disconnected? (if its Above KVA rated one)
what is photo voltic cell,& what are the materials associated with that?and any spcifications like volts/cm etc?
How to checked frequency drive output voltages?
Why are the laminations insulated from each other?
Suppose a 3 phase, 2 pole, 440V induction motor is driving a flywheel of 600mm diameter, 150kg mass. By using v-belt and pulley, the speed is increased to 4500 RPM. What will be the effect on motor current?
If not into production, how far did you follow the design and why did not you see it into production?
