What is RTCC panel and why it is required
Answer Posted / edwin aguinaldo
RTCC is REMOTE - TAP -CHANGER - CUBICLE and composed of AVR automatic voltage regulator which regulate the incoming supply voltage from the transformer using VT or voltage transformer (voltage ratio). RTCC control the MDU motor drive unit which control the OLTC on line tap changer position giving number of step + or - ,OLTC is connected to multi tap winding of HV side of the transformer.
Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
I am B.E.electrical engineer having 7 years of experience in Transformer testing upto 315 MVA.I want to khow how I can get the 'Electrical Valuer' License.
i have attended the interview on 4th June,08 at Kolkata in IOCL, can anybody tell me what is its result
Dear all, I want to use Induction motor to open and close a 1 ton door. How much power do I need. Thanks
what is meant by surge? what we called for high currents?
Can i use the B-curve MCB instead of C-curve MCB
if we look on phasor of the transformer vaoltage is 180 oppsite at primary and the secondary so to improve a power factor is secondary should kept negative to improve it primary side means is -.90 became +.90 at other side
What is the difference between earthing,ground&nutral?
if in 3-phase system voltage=440V,frequency=60Hz, current=400A. then if it is single phase then current=? and if it is single phasing then current=?
why 3 phase is converted into 2 phase using electronics circuit why not 2 phases are diresctly putted from the 3 phase transformer??
I WANT TO INSTALL LIGHTING ARRESTOR ABOVE 20 FEET HEIGHT INDUSTRIAL BUILDING. NOW IT WAS 15 FEET HEIGHT HOW MUCH DISTANCE IT WILL COVER & HOW TO CALCULAT THE DISTANCE COVER BY THE ARRESTOR
HELLO SIR, IAM PREPARING HPCL EXAMS. SO PLS SEND MATERIAL OF HPCL ELECTRICAL ENG..TO VIJAY_8888@YMAIL.COM
What is the count of hvdc transmission lines in india?
what are the standard IR values should be of R-E, Y-E, B-E, R-Y, Y-B, B-R of VCB in closed condition and in open condition for 500KVA & 1000KVA transformers. and what is the acceptable range when tested by 5000V megger.
what is through fault?
Is it required to use Automatic transfer Switch in L&T panel board if we use AMF panel with DG set? How the single line diagram will be? Please forward the material to sreenu_207@yahoo.co.in