Interested to Buy Any Domain ? << Click Here >> for more details...
what is sequence table in DCS . make a logic in sequence table
for tripping of ID fan in Boiler(in YOKOGAWA CS 3000 DCS).
- 1 Answers
- 7611 Views
- Yokogawa, I also Faced
- E-Mail Answers
Answer Posted / rajkumar
Sequence table works only in auto mode it have 32 conditions and 32 actions
| Is This Answer Correct ? | 2 Yes | 2 No |
Post New Answer View All Answers
how to work MIL contol valve posistioner ?
How does a single acting, spring return ball valve actually work? Does it require continuous air supply?
How many ohms are required for proper earthing?
what different types of problems do occur while doing instrumentation commisioning and how to solve them? please explain in detail
What is difference between Ionization heat and bimetallic heat
how can be calibrate flow indication transmitter (rosemount) it shows excess milli amps nearly about 24 ma on full scale, but its scale was set on 20ma on full scale..???how can be simiulate..???
How to calibrate RC Feeder system in thermal power station?,If any instrument available to calibrate it,ple inform me. make:stock,
please send the sample qustion paper for iocl written test ..
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
What are the key features of a Distributed Control System? describing the various layers (sensor through to business system interfaces) as well as the hardware, software and security aspects of the DCS.
Hook up resistance decade box to temp.transmitter.
what is installation and commissioning of (fat & sat) of power plant dcs ? this question keeps in desirable conditions of one company .
What inherent design and operating principles are included in a modern control system to use predictive maintenance practices to increase overall system reliability?
Why use ball valves on Gas pipelines instead of gate & or globe valves...means basic diffrence or use of these valves..how designers knows this type of valve with rating is required...
How to do gas analysers calibration in AUTO and Manually by using zero and span gas?
