Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between AMF panel and DG
Synchronization panel? please define the working of both
the panels?
- 3 Answers
- 35245 Views
- ABB, Power Grid, I also Faced
- E-Mail Answers
Answer Posted / bhupinder singh verma
AMF Panel: is Auto Mains failure panel. When the EB power goes off with a time delay signal will go to DG self
starter to start the DG. And when the EB power
resumes,after definite time delay stop signal goes to DG
and EB supply contactor will become ON.For a fraction of
time power will not be there for the utilities.
In synchronization OF DG SETS, When the EB power goes off with a time delay signal will go to DG self starter to start the DG AND WHEN THE LOAD REACH THE 90% CAPACITY OF THE DG-1 THEN THE DG-2 WILL START AND THE DG-2 gen-set is to synchronize with the existing DG-1 THEN ,we've to match the magnitude of the voltage, phase angle and the frequency and then only we've to switch on the incoming set's breaker. THATS WHY THE OUT PUT SUPPLY SUPPLY OF BOTH DG SET WILL RUN ON THE SAME COMMON BUS BARS ( MEANS- DG-5OO KVA / DG-2 380 KVA THEN THE TOTAL LOAD IS 780 KVA ON COMMON BUS BARS ) IN THIS WAY WE CAN SYN. ELECTRICAL CITY BOARD POWER AND DG POWER ALSO.
| Is This Answer Correct ? | 8 Yes | 1 No |
Post New Answer View All Answers
how to test power transformer.YNd11
can we use CBCT in neutral of solidly grounded transformer? in place of three phases we can pass only one phase which decreases the size of CBCT?
How the annunciator works ? How to do its wiring
what is the difference between neutral and earth
How to find ampere on ht side for selection of cable size ???
What is the minimum IR value of HT/ LT cable? Pls post separetely!!!!!
we have a 2.5hp Starite electric motor water pump,the elec motor burned out,we need to replace starting capacitor(old capacitor specs erased),what microfarad rating capacitor do we need? 110-125V
what is transient enclosure vltage , very fast transients, very fast transient over voltages
How many types of colling system it trformers?
Why in ESP Positive earthed
Do u know any one? how to find out in motor rated amps? formula?
How one can check the MAIN of a house wiring ?
please describe the Transformer setting, Motor setting, I/C setting, Tie setting
Why do we pefer VCB over OCB?What are the advantages of VCB over OCB?
what is the minimum pay scale for electrical engineer (building construction)in kuwait? plz revert back with yrs of experience & pay scale respectively.
