Interested to Buy Any Domain ? << Click Here >> for more details...
What's the difference between cold loop test and hot loop test?
- 5 Answers
- 43286 Views
- I also Faced
- E-Mail Answers
Answer Posted / ravi
1.Cold Loop Check
This is an electrical continuity check to confirm wiring integrity from control panel's terminal block to the field instrument. Please note that field cabling starts from field instrument and goes through Junction boxes and marshaling cubicle to reach termianal blocks of the control panel
2.Hot loop check
After successful cold loop check, each I/O is subjected to hot loop check. In this testing entire loop functionality is checked by simulation of the signal with power up from DCS or PLC
1.Calibration range
2.Activation of inputs / outputs / Field switches / Solenoids
3.PLC/DCS register updates
4.SCADA updates
| Is This Answer Correct ? | 102 Yes | 2 No |
Post New Answer View All Answers
Which type of pressure can be measured by these elements?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
What is modbus?
what is commisioning procedure,2)what is is the main work in commisioning in the field tx to dcs, plz send me detail
What are the uses of orifice plates?
Full form of KKS when use DCS.
How to Calibrate Ultrasonic Level Transmitter in field
plz send me general of ongc
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
Is it ok, to use non-contact type Radar type LT, on a tank that is half circular from the bottom side? If yes the, isn't the waves gonna bent in other directions?
How to convert mmWc(mili meter water colam) to tph(ton per hour)?
Calibration of controller (pneumatic)
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
Which language of programing is popular? how can i learn it ?
How to calibrate an pressure gauge with yantrika test bench?
