Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / eid elatawy
First i have to know the connected element
1. RTD :using resistance box and divide the range into 4 quarters for example the range 0 to 100 deg we have 0,25,50,75,100 will find the related resistance from the table and see the transmitter output and if any deviation will make trim zero and span trim.
2. TC the same idea but we use MV supply and by using TC tables.
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
plz send me general of ongc
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
what happen if i increase height of displacer type LT.accuracy or sensitivity are affected.why?
hi friends,im an instrumentation and contol engg student,can u hlp me of suggsting barc written question paper,my id is roysuvaranjan@gmail.com, cel no.9563591747
What is ultrasonic flowmeter?
plz tell me clearly about PID.."when v have to change I value,D value,GAIN??
why fuse block is not used for AI signal?
why use 50% lel methane gas concentration for gas detector calibration instead of 60% lel gas concentration whereas the hi alarm set at 60% lel.
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
State some of balance principle’ advantages?
If fire would be inside the plant which fire detector is to detected the fire.
Name different types of bourdon tubes.
Why we are using reverse action in displacer types level transmitters on some Vessels?
What is solenoid valve? Where it is used?
Calibration procedure for water rotameters
