what is DG synchronization panel
plz explain the working!!!!!!!
- 12 Answers
- 93548 Views
- Kirloskar, Lanco, MPS Techologies, Sedemac, I also Faced
- E-Mail Answers
Answer Posted / syamkumar
DG synchronization panel is required to parelleling of 2 or
more DG's it may be as per the load dependent .one DG will
be ON as per the master and other will synch oce the
Frequecy ,voltage matches with master DG .this is required
to share the load.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is bridge rectifier and explain with details
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
I have experienced electrical maintenance HT ,but I completed be ECE ....can I apply c license or not ???? Pls help me friend s...
what is booster? and how it is connected in a circuit?
What is difference between SMC supportg and Glass Fibre Reinforced Plastic Support.
What is Instantaneous Earth fault relay,how will work
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
what is the power rating of CPU, CRT type moniter, LCD type moniter,scanner Approx.
The moisture in air will condense at
What is block diagram?
What is the power factor of an alternator at no load?
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
Working of microwave oven?
Any one can explaination about calibration with rotating sub standards?
why the making current is more than then the breaking current and if its true then its about a controling circuit or breaker power contact points
