Interested to Buy Any Domain ? << Click Here >> for more details...
what is DG synchronization panel
plz explain the working!!!!!!!
- 12 Answers
- 98636 Views
- Kirloskar, Lanco, MPS Techologies, Sedemac, I also Faced
- E-Mail Answers
Answer Posted / syamkumar
Dg Synchronization panel used to 2 or more dg sets.
because load sharing perposs.
first master dg start upto 70% load increased to another dg will start that time voltage,HZ,RPM its to match only two dgs syneh.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
What is the requirement of grounding the neutral of single phase generators on load? If the neutral is not grounded, what will be the effect?
What is critical disruptive voltage?
why we use single core 630mm2 cable for transformer secondary side
im working in one private compeny in gujarat. i was complet diploma electric in 2010 from gujarat technical board. now i want electric supervisor licence in gujarat but i dont't know when i apply? plz give me address of the licence dippartment office in gujarat. gandhinagar
what is the difference b/w pvc cu conductor and cu breaded wire..?
if an insulated power and control cables of a running gas diesel gensets laid direct in an open trench i.e, trench bed is not rcc of a power house in which rain water, spillage water alwas exists and all power control cables remains submerged even when gas gensets of 480 kw each runningin on load. These power &control cables runs from power house to switchgear room through these trenches in which water remains most of the time. pl explain its merit & de-merit
WHY DO VOLTAGE TRANSFORMERS FAIL DURING EARTH FAULT IN THE DELTA CONNECTED 6.6KV ELECTRICAL SYSTEM
is it true there's a big difference in using Cummins or Denyo...especially power output or leakage
What is meant by coupling capacitor?
As i want some model question paper in basic computer science and history please send me immediately sir
how does a submersible pump work..?
What is the minimum distance to be maintained in between HT panel and LT panel and Instrument panel as per IEC and NEC standards?
How to calculate no of EARTH PIT? Describe the formula as per IS standard?
What test must you do before powering up a circuit that you have been working on?
how to select energy meter? have any calculation?
