Interested to Buy Any Domain ? << Click Here >> for more details...
Can a pneumatic control valve work without positioner?
- 4 Answers
- 8237 Views
- SMC, I also Faced
- E-Mail Answers
Answer Posted / tickno
yes it can ,but if the bench set of CV is on range 3-15 psi(instrument standadt unit,conversion from 4-20mA to 3-15 psi)
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
Can anyone send most commonly asked interview question in Oil & Gas industry
How to convert Differential pressure to flow in TPH
Can Any body tell me how to check Modbus Settings in ER300N L&T trivector meter?
What is the use of single seated valve?
principle of dead weight tester ?
What is motion balance principle?
Why not come out analog output in ABB EL3020 when display show correct value
What is the use of gauge?
There are two chlorination tonners both are connected to two pressure swithes and the pressure switch is connected to SOV which operates the valve to changeover the tonner selection i.e if pressure one tonner goes low the other tonner should come in line if it is inautomatic selection design a circuit using relays ?
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
How to change dcs card in online. (Dsc is maxdna)
can you provide me full detail about instrumentation in ONGC??
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
In turbine what does term CDP, NI, NH, HSSOC means.
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
