Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / gogarlatatarao
Basically starter is used for purpose of limiting the starting current ther by it protect the equipment ( motor and generator)from high current , thus the windings of equipment are protected.
If no starter is used then the starting current will be huge which damage winding.
I.e v=ir,
I= v/r
I=220/0.2
I=1100Amp. which is dangerously high
Where as in case of transformer to protect it from high inrush currents the windings are mechanically braced to with stand these forces.
That's way no starter is used.
AND
Starter is used where breaking and starting operations occurred mostly.
But if once we start the transformer we can't break it until any abnormal condition occurred.
| Is This Answer Correct ? | 11 Yes | 1 No |
Post New Answer View All Answers
How many types of electric motors are there?
How many types of faults are there in 3 phase power system?
What is the difference between security constraint unit commitment and security constraint optimal power flow?
What are books to be referred for KPTCL exam?
Earth bits close or open. Which is correct
What is the formula to calculate the size of Aluminium and copper cable?
I want to calculate how much capacitor we connect to maintain the unity power factor? Is there any formula? Pls give me the answer
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how to test the electrical panel.ht lt mcc pcc.
In synchronous motor, how the field current is related to armature current..i know its inversely proportional..but concept wise...i was nt clear....pls help me...
After completing iti in electrician, how can i get certificate of electrical supervisor? What ia requirements. For it?
How can we calculate ac current from the given DC current when AC voltage is given?
WHAT IS SITTING AMPS IN OVER-LOAD RELAY FOR 1PH OR 3PH MOTORS?IF ITS NAME PLATE GIVEN MAX AMPS 10AMPS?
1.why we are using metal oxide gapless block in lightning arrester,2.What is minimum and maximum rating of metal oxide blocks using in india
How to calculate the no of Ceiling fan (1200mm sweep) per unit area?
