Interested to Buy Any Domain ? << Click Here >> for more details...
a 3 phase slip ring induction motor is wound for 4 poles on
stator and 6 poles on rotor; when 3 phase balanced voltage
source at 50 hz is applied to motor it will run at
a)1500rpm b)1000rpm c)750 rpm d)zero rpm
- 13 Answers
- 26418 Views
- Essar, PSPCL, PSTCL, I also Faced
- E-Mail Answers
Answer Posted / lolipop
Answer is d.) as it looks more nicer and more lengthy
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
How much depth n width required for laying of 1X70 Sqmm Cable in Desert???
Define load factor?
How to Calculate the Fault Level of Electrical Installation
How equivalent impedance is calculated in thevenin theorem?
WHAT DO YOU MEAN THE DIFFERENT TYPE OF CURVES OF RELAY LIKE STANDARD INVERSE, VARY INVERSE, NORMAL INVERSE, LONG INVERSE ETC....
WHAT IS SPEC OF CLEANROOM MOTOR AND LIGHT FITTINGS?
What are the causes of having an rmu explode after installation? And how do u treat the bushings of an rmu?
What is the difference between resistance grounding system and resistance earthing system?
What are the causes for the failures of sandwich type (Al) busducts?
Is single load(eg: three phase motor) having all the components like positive,negative,zero sequence components during fault condition?
Installation method of self treated earth electrode.
what is quality factor in series resonance circuit and calculate the factor of voltage magnification? how it happens?
current transformer balance the power level on both sides. e.g in case of step up, at secondary side voltage rise but current decrease and vice versa in case of step down transformer. but how this power level remains same in case of current transformer and voltage transformer
What will be the size of copper cable (each for 3 phase and 1 neutral) from Service connection Kit-Kat to Panel Board (i.e. to main switch) for a 6 pole 3-phase AC induction motor of 200 H.P. capacity? Amp-255 A, Frequency:- 1450 rpm.
Stator of 3-phase IM has 3 slots per pole per phase. If supply frequency is 50 Hz, calculate the speed of rotating stator flux A 1000 rpm B 500 rpm C 1500 rpm D 1440 rpm
