Interested to Buy Any Domain ? << Click Here >> for more details...
What is the procedure of DP switch calibration
- 2 Answers
- 10912 Views
- NOCL, I also Faced
- E-Mail Answers
Answer Posted / inst
DP switch have two ports that is high and low..Example : Our s.p is 50 psi...Forfor this we have to apply pressure to high port at the same time lp port should be open to atmosphere..When pressure reached 50 psi switch contact will be changed..
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
Give Detail information about plc,dcs,and scada system?
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
what is the difference between active & reactive power?
why we are using magnet for calibration of gas detector?
hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....
Explain pH, Conductivity.
Why flow/pressure transmitter before control valve?
Draw symbols of the following :
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
What is the start up procedure of desalter
Which type of pressure can be measured by primary elements?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
What are different types of orifice plates? State their uses.
draw shematic diagram of c/v positioner(smart type)?
which processor is used in dcs.
