Interested to Buy Any Domain ? << Click Here >> for more details...
what is water cement ratio and how to calculate it after
designing the concrete?
- 6 Answers
- 13768 Views
- Schlumberger, TATA, I also Faced
- E-Mail Answers
Answer Posted / kannan t
Water cement ratio will be defined by the workability of concrete. i.e by slump test.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
what is high type road and low type roads
Design a shear wall of length 4.20 m and thickness of 250mm subjected to the following forces.Assume Fck = 25Mpa and Fy = 415Mpa and the wall is a high wall with central part 3440mm x 250mm and two 380mm x 760mm strong bands at each end with following loading. S.No. Loading Axial force Moment Shear 1 DL+LL 1950 600 20 2 Seismic load 250 4800 700
why demand factor less then 1 ?
what is the cost of rcc roof casting of 400 sq. ft. in kolkata
In block work seawalls what is the purpose of slip joints?
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream
please, what is the required bar for a column of 6mx6m the dept is 405mmx300mm,its an axially loaded ?
how many men days of loburs and masons are requirete for 1 cum,pcc (1:2:4),Pcc(1:3:6) and Pcc(1:4:8) thanking you
Is it necessary to apply tack coat over the primecoat. IF not what happens.answers other than 1.to superimpose the next layer(2) to adhere the layers so as to form homogenity.
Can we use Polystyrene as a Bitumen modifier !! if so is it a good MS research topic ? and what type of laboratory tests will be conducted during Research work ??
What are the uses of layer?
What materials were used to build the golden gate bridge?
How to determine dia of steel for use in column,slab etc. i mean how to calculate the diameter of steel which is to be used in structures.
how much required strength of cement concrete bricks(size 230x115x75mm)
On what basis we decide the formation level of the road? other then that of 50% Cutting and 50% Filling??
