Interested to Buy Any Domain ? << Click Here >> for more details...
what is pf. how to calculate capacitor bank value to
maintain unity pf.
- 18 Answers
- 59650 Views
- JH, Saint Gobain, Supreme Treves, I also Faced
- E-Mail Answers
Answer Posted / sm
pf is the cosine of the angle b/w voltage phasor and current phasor. To maintain unity feedback the capacitor bank value should be such that it compensates the inductive reactance value in circuit i.e., X becomes zero. Thus, the circuit becomes purely resistive and pf is unity.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
need to make a report. Need to choose a 3phase induction motor. Load conditions motor will operate in : Maximum Load: 30 Kw Speed: 2950 rpm Ambient temp: 20 cent Supply voltage: 440V Frequency: 50Hz need to look for the safety factor when choosing the motor, went through catalouge found a few, but dont know how to choose the safety factor allowing an extra load something above 30 KW to avoid any harm.
H.t motor 6600 volt to same motor lt supply 440volt supply applyed to h.t motor to effect....
WHAT IS MEANT BY INSULATION CLEARANCE IN VACCUM?
what is apparent poewr, reactive power, & active power?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
What happens if the negative to earth voltage is greater than positive to earth voltage in the battery of substation?
What is the IS standard for MCCB to be use (As per capacity of AMP)& for ACB also.
1) What are your personal strength? 2) What are your personal areas of improvement? 3) What are your expectations from from a particular job? 4) what are your carrier objectives?
If I have Energy Meter Ratio as 100:5 & Also I have CT Ratio as 50:5 then what will be my multiplying Factor(M.F.)
What is Antipumping Function & If we have C.T how we find the Ratio ?
what is the solution for meger test failed the MV cable?
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
i have 90kw motor.so i choose connect cable .please what is parameter checked so please give to formula
in the directional overcurrent and earthfault protection,normally we are setting the angle 45 deg lead for phase fault overcurrent and -45 deg lead for earthfault fro forward direction.but both the fault are operating on the same angle region only.why?how the relay will response?
how to design the heater in temperature control unit to heat 50KL of water?
