Interested to Buy Any Domain ? << Click Here >> for more details...
what happen if the battery is charged by more than one source ,for ex: connecting data cable to laptop & charger pin to source supply ?
- 2 Answers
- 4494 Views
- I also Faced
- E-Mail Answers
Answer Posted / nibel
actually the battery charger should deliver 10-20% more than the battery voltage rating. if its exceeds there will be the chances of explosion.
no need to worry about the polarity but the voltage rating matters.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the importance of counter based plan & how is it scheduled?
Differentiate between digital phase converter and ordinary phase converter.
how circuit breaker work.. what is the operations taking place inside a circuit breaker when an overcurrent occurs... is it similar to fuse?
HOW TO CALCULATE THE HEAT AND LOAD OF LT-SUBSTATION WHICH CONTAINS 2*1MVA TRANSFORMERS,LT-SWITCH BOARD,MLDB,ACB,BUSBAR,ETC,......?
l&t switch FN 63 handle position can we change
STATE WORKING OF VACCUM CIRCUIT BRAKER?
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
Why ground terminal is used in pot meter 10k ohms
what is high - pot test. what's its use?????
What is phase cross over frequency?
all interview questions with answers of ntpc (2000-2009
description about dry type transformers
In constant power region of 3-phase IM torque-speed characteristics, if frequency increases flux A does not alter B decreases C increases D none of above
How to select the proper VSD to operate high inertial load
how is control wiring coding is done in a CRP panel ?
