Interested to Buy Any Domain ? << Click Here >> for more details...
WE Know that different supply voltage of solenoid valve like 24,110,220 etc..how we check the solenoid supply is 24v or 220 NOTE: No specification at device.
- 2 Answers
- 10071 Views
- OMV, I also Faced
- E-Mail Answers
Answer Posted / ayaz
MR Carl Ellis
Solenoid in workshop not in service and no specification on the solenoid how to know we usage solenoid
for example field supply for solenoid is 24 v dc and no new in warehouse and how to check and use older solenoid without specification
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
typical loop drawing of a simple feedback control comprising of one transmitter and one control
Capacitance, resistance ( colour coding ), parallel & series circuits.
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
what is the input to be given in digital flow meter during the the calibration time?
State bernoulli’s application.
State four different types of flow measurement, for gas flow measurement MMSCFD is the common unit expand the unit and specify significance of word S in the unit.
We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.
please send the sample qustion paper for iocl written test ..
Where Can i take a SPI INtools training in Mumbai? In Rolta India Ltd to whom I should approach regarding of SPI INtools Training?
what is function of sensor, and how is it work , explain with difination
How does a single acting, spring return ball valve actually work? Does it require continuous air supply?
In control valve proximity inductive sensor is taken as digital feedback for full open and full close.Normally its volts 24v when the sensor acts the feed back voltage 14v so that our relay not indicating in plc panel . kindly give the solution.
I am using 971 Enraf radar level transmitter for LPG tanks ,the tank side indicator gives the error code 999999999FL can any body give me any diagnostic for this issue?
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
