Interested to Buy Any Domain ? << Click Here >> for more details...
why we are giving negative supply for vibration sensors?
- 3 Answers
- 11459 Views
- Shell, Solex, I also Faced
- E-Mail Answers
Answer Posted / mohammad javed
Don Bentley uses the PNP transistor which works on negative bias voltage. That why a negative voltage is used in vibration sensors. It is the circuit design which require negative voltage.
| Is This Answer Correct ? | 3 Yes | 4 No |
Post New Answer View All Answers
In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.
what will the sending unit in the fuel gauge utilizes?
WHAT IS TMXT IN TEMPERATURE FOUNDATION FIELDBUS.
How oil line flow measured?eplain about instruments used and working principle?
what is the diffrence between pressure safety valve & pressure relief valve....pls
how to check earthing,what is minum ohms for proper earthing
For what reason would you possibly be compelled to make use of a Smith Predictor. Explain the idea behind the operation of this device.
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
Specific gravity.
In my company plc based winders are operated. one day there was a data transmission failure alarm shown on pc. as per sir instruction we have reset master plc but winders were not triped and alarm gone. so what master plc do?
How to interfacing microcontroller with a DC motor
what is sil (safety integrity level
How we connect a instrument with ground, Give brief explanation with help of diagram?
(1) In turbine, what does term CDP, NI, NH, HSSOC, means. (2) What is the purpose of LO overhead tank in turbines.(3) An equipment is certified for EEX, IA, IIC,T6, what do you under stand by this.(4) what is SURGE, and how it is prevented, what is the purpose of bypass valve across AS valve.(5) Give 2 application of quartz crystal used for process parameter measurement.(6) what is meant by cold float of compressor shaft. (7) state four different types of flow measurement. For gas flow measurement mmscfd is the common unit. Expand the unit and specify significance of word S in the unit.(8) what is meant by Gap voltage, in vibration measurement. Normally how much Gap voltage is set and state the reason.(9) what will the new flow factor if D/P transmitter is Re-Ranged from 25” wc to 50” wc.(10) what is the usage of QDV & Volume booster.
WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?
