Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / makinde motunrayo
Milivolt
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
Can anyone send most commonley asked Instrumentation questions and answers in cement industry please?
Differentiate between ultrasonic flowmeter and radar type flow meter
what is the importance of CV in the control valves? how it is calculated?
what would be the minimum flow rate that we can measure on rotameter..?
if in a level tx height is given, how u calculate the ranges of the tx?
Hello to all....I am an Instrumentation Graduate and i am passed out in this year only.. I am unable to find the job in my core instrumentation.. so any boby tell me how to and where to search the job....please...and also tell me i there are any courses offered in the instrumentation stream so i can do it... you can send your suggestions to my mail-id i.e Ganesh20084u@gmail.com ... please..
What is the PLC configuration in Cement industry?
when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??
Why the ammonia and Nitric Acid level indicators is with millimeter ? and What is the conversion form millimeters that level indicator indicate to weight ?
what is Best Among SINK Or SOURCE Type Design In Digital Signal, Either Iput Or Output? WHY?Can any one..
How to Calibrate Vortex Flow transmitter in field
A valve in series with an orifice plate (DP transmitter), is aligned for constant pressure in the pipeline, if there is an error dx, How to align it in process.
Can Any body tell me about the Contact or Email id of any good Consultancy which help me to find a job in Instrumentation Field in India .I have Six years of Work Experience in the Same field.Please revert me back on shammi_gwalior@yahoo.com ?
What is standard of DCS panel design?and what is step of DCS panel design?wiring and type of connector(screw or DB connector)
Why does a pressure gauge installed on reactor, doesn't have any vent line below to release the pressure? Is it any kind of designing mistake or it actually does not require any vent line? And if it does not require any vent line below it then how we are gonna release the pressure built inside the pressure gauge?
