Interested to Buy Any Domain ? << Click Here >> for more details...
why we are giving negative supply for vibration sensors?
- 3 Answers
- 11452 Views
- Shell, Solex, I also Faced
- E-Mail Answers
Answer Posted / carl_ellis
Because negative voltage is what the Bentley Nevada circuits use.
The regional guy from Bentley Nevada was in the other day so I asked him. His answer, "Historical legacy. It's always been that."
The point is, if the circuits need a negative voltage, that's what's used.
Carl Ellis
Measure First
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
What is Erosion in a control valve?
what can of fault ofently come in vibration mesurement?
why we take %i0.0 as input for twido plc
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is actual drum level and compensated drum level?
1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.
I installed the smartplant instrument v8, but can not be opened, that always said: "INTools 2007 hardlock no found". So Could you help me how to do for that?
What is the working principle of the magnetic meter?
how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?
what is span value and zero ? and how set ?
Who to difference between analog in & analog out in dcs?
define feed forward control loop with example and drawing?
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
How RAL(Rotary air lock)works in cement industry?
