Answer Posted / sfz ans
Assume size of bricks = 0.19m x .09m x .09m
therefore size of bricks with mortar (assuming 20mm of mortar filling betn two bricks ie: each brick gets 10mm thick layer of mortar at their face) = 0.2m x 0.1m x 0.1m
now divide the area depending upon the type of masonary work ie: Streching bond, flemish bond etc
eg:
Streching Bond for 10 sqm
no. of bricks = 10/(0.2*0.1) = 500 bricks.
Streching Bond for 1 cum work
no. of bricks = 1/(0.2*0.1*0.1) = 500 bricks
Is This Answer Correct ? | 11 Yes | 0 No |
Post New Answer View All Answers
i need the syllabus for the direcr recruitement of executive engineers in andhrapradesh
How we calculate the service time of buildings
which is the cheapest type of flooring (say for using for 6 months in a factory building & dismantling it)?
what is meant by shear center?????
what is project?
how to calculate Rate of analysis for 100 m3 Any ratio of concrete ? including labour
What are the applications of the modulus of elasticity?
What is the average density of soil?
What is meant by Crystal Concrete?
how much area can be platered by a mason for exterior
how to calculate the strength of rebound hammer test reading in building construction ?
hoe much fine & sourse agregate required for concrete mix of 1: 1.5:3 by volume in Cu.Ft
at which depth the construction of tunnel is economical from cost and engineering aspect.
What in your past experience or education prepares you for the position for which you are applying
asubmerged weir is one in which the water level on the down stream side of the weir is just at the crest level below the crest level above the crest level at stamp elevation as water surface on upstream