Interested to Buy Any Domain ? << Click Here >> for more details...
What command displays the OSPF Process ID, Router ID, Address summarizations,
Routing Networks, and passive interfaces configured on a router?
- 1 Answers
- 9825 Views
- I also Faced
- E-Mail Answers
Answer Posted / parshant jaswal
show configuration or show running-config
| Is This Answer Correct ? | 5 Yes | 2 No |
Post New Answer View All Answers
How many ways to access router?
Which protocol can do load balancing on unequal cost also?
what does PPTP use for encryption and authentication?
What are the different types of cables that are used in routing?
Explain the draw back of ospf protocol?
What is default packet size of ipv6?
What is GRE in PPTP?
When does network congestion occur?
What is mac address size of ipv6?
Which classes are assignable?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What is hsrp?
What’s the easiest way to remotely configure a router?
After how long ospf exchange its topology table?
On which layer does L2F, PPTP and L2TP operate?
