i am having a 3 phase 12.5HP motor,that is connected in
Star/delta.Without any Trip that motor stopped suddenly
why?
- 8 Answers
- 7314 Views
- I also Faced
- E-Mail Answers
Answer Posted / sheikh
this is not possible that without any reason motor going to
be off . your star delta control or power circuit may be
wrong other wise motor may be faulty.
| Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
What is difference is of VSD,VFD,VSDS, are they the same as the direct current to control dc using above mention
If one lamp connects between two phases it will glow or not?
I have one ct of ratio 3000-2000/1 Amp its knee point voltage mentioned on name plate is 500-333/30mA-50mA at Vk/2. in secondary box there is three terminal named 1S1, 1S2, 1S3 then on which terminal obtained the knee point voltage ie 1S1-1S2 OR 1S1-1S3 & also specify the knee point voltage for the ratio 3000 from name plate.
If UG power cable both ends are to be earthed or what? If not why?
sir please send me iocl written test paper in my e-mail account. i'll be obliged to you........ thank u roshan
How to calculate fault level of 11 KV system
how to maintain frenquncy with syncronising sub-station for distribution
What is the range of the stator resistance of 3 phase induction motor?
how you will decide the distance between the power transformer and its fencing
how to test the electrical panel.ht lt mcc pcc.
Why MCCB is Getting tripped sometimes when there is no load in the Midnight ?
wheather the size of windings in motor and generator are the same
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
what would u consider to be the basic purchase order information you would need to proceed with a cable inspection assignment?
