why we usually call 415 volts instead of 440 volts
- 3 Answers
- 6715 Views
- S Tech, I also Faced
- E-Mail Answers
Answer Posted / keval
Becoz of the tolerance of 10% allowed....
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
what is feed back and what are feed back amplifiers?
I want formula to calculate current loss with distance in km.I searched many sites but didn't right answer.Plz reply me
State the factors, for the choice of electrical system for an aero turbine.
in an electronic tri vector meter when the current and voltage sequence changes ? what is the effect of phase sequence on recording of meter
How to convert a two phase power into a three phase power in induction machine?
What is “pu” in electrical engineering?
What are the advantages of stationary armature and rotating field system?
How many kinds of E.L.C.B and how to work E.L.C.B
how to calculate mf when meter and cTPT detail are given
How many types of colling system it trformers?
what is meant by residual over voltage & residual earth fault ?
Can we Co-ordinate relay in Load Break switch?
What is q factor?
Give two basic speed control scheme of dc shunt motor?
In between UPS out going changer over switch and ups raising main input, both side cable gland producing heat but the cable doesn't get heat,Why?
