when we workout quantities of reinforcement steel , whate
are the critari of lap length for column
- 4 Answers
- 7893 Views
- ACC, CPMT, L&T, I also Faced
- E-Mail Answers
Answer Posted / deepak katyal
It depends on grade of steel of concrete. Higher the grade lower the lap length.
Genrrally we take it 50D.D is dia of steel bar here.
| Is This Answer Correct ? | 6 Yes | 1 No |
Post New Answer View All Answers
if we know load bearing capacity of the soil and building load falling in each footing, then how to choose the type of foundation??? and if it is shallow foundation then which type of shallow foundation should be choosen i.e either strip or isolated or raft or combined or cantilever footing???????
what are the types of design? which type of method is used at what type of design & why?
Explain what is zoning permit?
where will be the reinforcement of slab placed when there is an inverted beam and the bottom of the beam and slab are at same level ?
if dia of slab beam bar is38mm what its clear cover any method of provide clear cover
why we use aggregate,sand with cement in concrete?
residential buildings,mixing of concrete,structural,construction material,site handling.
explain the advantages of total stasion
what will happen if one could not properly follow the spacing of slab reinforcement bar?
explain fie benefits of using standard terminology in the measurement process
Rate analysis of Vitrified tile in cement mortor 1:3
Civil engineering material testing Standard results
1.what type of the rock is most suitable for wet mix macadam in construction of road? 2.what is the highest maximum dry density and optimum moisture content can be acheive by using most suitable crush rock?
Can we apply curing compound on ceiling (slab Bottom)
How to testing voids of filled aggregate in bitumen mix design
