Interested to Buy Any Domain ? << Click Here >> for more details...
IT IS SAID THAT THE OLTC OPERATION SHOULD NOT BE PERFORMED
WHEN THE TRANSFORMER IS GENERATION TRANSFOREMR/STEP UP MODE.
WHY IS IT SO?
- 1 Answers
- 3834 Views
- MSETCL Maharashtra State Electricity Transmission Co Ltd, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
With OLTC ,voltage variation is in increments which may not
be the requirement or may affect unit diff relay . When
the required voltage can be obtained by varying excitation
,OLTC is not needed .
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
If short circuit ratio is high is it bad or good for a machine then tell the reason...
What is shutdown of electrical sub station?
Define what is difference between fuse and breaker?
If we need4× 50mm sq cable but it's not available so we can pull 4×25mm sq 2cables
Explain bypass capacitor?
How to calulate Locked rotor amper(LRA) for compressor type motors?
what are all the components required to assemble solar panel other than pv cell?
why HT armoured cable does not glanding
What is electrical cable termination
I WANT TO INSTALL LIGHTING ARRESTOR ABOVE 20 FEET HEIGHT INDUSTRIAL BUILDING. NOW IT WAS 15 FEET HEIGHT HOW MUCH DISTANCE IT WILL COVER & HOW TO CALCULAT THE DISTANCE COVER BY THE ARRESTOR
How can we select suitable capacity generator for three phase load (inductive load) and how to take study analysis in 3 three phase load system ?
Why neutral point is consider as zero potential?
A 10 MVA, 66KV, 50Hz, Y-connected 3-phase alternator has synchronous reactance of 0.635 Ù. It is working at full load at 0.8 lagging p.f. condition. Find torque angle, neglect armature resistance.
What will happen if the armature resistance is in minimum position and the field resistance is in maximum position while starting the motor
advantage of motor design on higher power factor . normally motors are designed for .8 power factor. what is advantage of designing at .88 power factor
