Interested to Buy Any Domain ? << Click Here >> for more details...
what is DG synchronization panel
plz explain the working!!!!!!!
- 12 Answers
- 98128 Views
- Kirloskar, Lanco, MPS Techologies, Sedemac, I also Faced
- E-Mail Answers
Answer Posted / arvind kumar pandey
Under fluctuating load,if load increasesthen other DG is
connected to Host DG,to share the load equally,now this
process of working needs synchrinisation with first
one...because as we know AC owns following parameter.
1: Frequency:-It is generally fix by manufacturer.( As
per "Indian Rule Of Electricity",in India Std Frequency is
50 Hz).
2:As in case of Three phase DG set each "Phase Angle" of
respective terminal should match with other one.
3: Before connecting to Grid,"Phase Difference/Sequence" of
each DG should mach with each other.
Under such condition when first Dg
reaches to its 70% load,Sensor command via PLC starts the
other DG set,Before connecting to Grid,all above mentioned
parameters are synchroninse with each other ,It is done
by "Synchroscope" & the process is known
as "Synchronization of DG"
| Is This Answer Correct ? | 15 Yes | 2 No |
Post New Answer View All Answers
What is the maximum No. of out going mccbs permitted from an LV distribution paqnel? What is the ampere relation between incomer and out going switch gears/mccbs?
What is meant by derating factor?
what is the responsibility of C license holder in industry?
Give details of your interested designation, the post you are interested to serve the company better and explain why you think you can serve the company better in such position if employed?
How to checked frequency drive output voltages?
. How to calculate the Short Circuit Impedance in Transformer? How to calculate the Short Circuit Impedance in Transformer?
what is meant by poly phase induction motor ? how its operating by single phase or three phase?
What are the major reasons for balancing hydro-thermal mix?
Define open loop control system.
What are the raitings of Mcb,mccb and Acb in detail ??
How to select the proper VSD to operate high inertial load
why we use 630mm single core cable for transformer secondary side and why two neutral cable
Meaning of ingrace protection for motor.for ex IPXY
Why do we mostly prefer to generate and distribute electricity in 3 phase and not in 4 phase or 5 phase?
How is magnetic leakage reduced?
