Interested to Buy Any Domain ? << Click Here >> for more details...
i want to measure voltage difference between neutral and
earth so i just simply use voltmeter.
my question is that may i use this measure continuosly.or
there are some electricity board restrication on that? or it
creat some problem on my measuring device..?
- 2 Answers
- 4379 Views
- NEEC, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
You can measure after the metering . Do not use service wire
or meter terminal
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
how unidirectional torque is produced in DC motor?
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
How do we arrive at selecting reactive capacitance value as 30% of h.p rating of motor?
Can we Co-ordinate relay in Load Break switch?
how to test the turn ratio of 3 phase transformer using volt meter shoe the curcit diagram.
Let me know that how i calculate the alternator sub tranciant reactance and tranciant reactance.
Can anybody inform me about the pattern of ECIL GET( Graduate Engineers Trainee) interview for Electrical students? Will there be HR round as well? I thought of preparing for 2 to 3 subjects thoroughly. Will it be sufficient? Please share your thoughts.
how can I calculate charging current of cable/overhead conductor? what is roll of voltage in it ?
how much cable size required for 70 kilowatt load.
Which type of a.c motor is used in the fan (ceiling fan, exhaust fan, pedestal fan, bracket fan etc) which are find in the houses ?
How does a battary stores charge in it? please explain in simple manner and in detail.thanks
any earth foult trip the relay but in welding time not trip by earth foult
3 phase induction motor connection star or delta while using ac drive motor is .75 to 5.5 kw
1. What is differential relay? How it operates? 2.How to calculate the Short Circuit Impedance in Transformer? 3.What is the alternate solution for testing of polarity by using polarity tester while its milli ammeter does not works? 4. While testing the 33KV Busbar by using Hipot kit, what should be the test voltage we have to apply? 5. What is the procedure/activities to be taken to inject the current more than 2000A by using 2000A Loading Transformer? 6. Explain how you can give the overload setting to any Motor Protection Relay for a HT motors with formula and example? 7. Why restricted earth fault protection is needed? Why can’t differential Protection is sufficient? 8. What should be the minimum and maximum ohmic value for earthing? 9. Why DC Currents are not used in transformer? 10. What is the Frequency while we step up the voltage from 220V to 11KV? Is it possible? Explain it?
IF alternator SCR value will be high means what happen in alternator efficency at operating power factor of 0.8
