Interested to Buy Any Domain ? << Click Here >> for more details...
why is a earth pit 10 ft usually? And, what should be the
distance betweeen two earth pit?
- 4 Answers
- 7127 Views
- I also Faced
- E-Mail Answers
Answer Posted / sasi karthick a
Resistivity of the soil will better when depth increases.
Soil resistivity test will conduct and the resistivity will
selected for earthing calculation. As per IS 3043, it
should be twice the length of the electrode.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
how to identify the cable quality and what is flame proof cable
what happens to the supply voltage if there is any change in frequency?
sir am giving jspl exam on 19th oct . i belong to eee, so plz send previous question papers ..........to dis id abhilash203@gmail.com
sir, what is the importance of Fault MVA. how to calculate fault mva of 33kv substation connected by 6.5 km line(single circuit with equal spacing) with 110/11kv transformer in 110kv susbstation.the fault mva on 11 kv bus in 110kv susbstation is 208mva.
What are the protection required for Transformer, motor, Line, Generator, capacitor, that all i have to refer which standard?(Like Transformer detail IS 2026)
what are inherent currents?
we need a ntpc previous papers
We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
How to set the relay,,??
could an induction motor be used for regenerative braking in electric-train control? in this type of application would some scheme have to be devised to obtain low synchronous speeds while braking? would induction-motor drive, therefore, be suitable for passenger service?
how can tell us the AC indoor or outdoor which Tr and formulls
while doing high voltage test on 11kv/433 distribution transformer why we only give 28 kv on hv side and 3kv on lv side for power transformers what is the value what factors it depends
What would be the size of wire used for 2 Ton of window A.C?
where lt & ht capacitor used
